Big bore engines are all about the flow, more air in and more air out, anything that slows that down, robs horsepower. The factory M8 intake manifold does a decent job in stock form, but starts getting in the way when trapped between 124 and larger cylinders.The stock polymer unit is also less tolerant of the additional heat that a big bore engine can make at full noise. The solution is the new S&S high flow cast aluminum manifold and a must have for top level performance in the M8 platform. Must have for big bore engines. T6 heat treated cast aluminum.
FOR CLOSED COURSE COMPETITION USE ONLY. NOT INTENDED FOR STREET USE. LEGAL IN CALIFORNIA ONLY FOR RACING VEHICLES WHICH MAY NEVER BE USED, OR REGISTERED OR LICENSED FOR USE, UPON A HIGHWAY. NOT LEGAL FOR SALE OR USE NATIONWIDE ON ANY FEDERAL POLLUTION CONTROLLED MOTOR VEHICLE UNDER THE CLEAN AIR ACT.
Before you unwrap your parts double check your fitment and once unwrapped, look the item over before trying to install it. If you can snap a picture of the damage and notify us ASAP we can replace the order right away.Notify us right away so we start the process. We're happy to step in and get the ball rolling.
An estimated restock date will be provided at the time of cancellation. This item is in the category "eBay Motors\Parts & Accessories\Motorcycle & Scooter Parts & Accessories\Air Intake & Fuel Delivery\Carburetors". The seller is "easternpc" and is located in this country: US.
This item can be shipped worldwide.